|
4. Installing USB
Drivers for Windows®
1COME VD100 has
custom USB drivers for Windows® that are shipped to you on the
software CD. Do not insert the CD at this time. To load the USB
drivers, first boot your Windows® PC. After Windows has completely
loaded, simply connect your 1COME VD100 to your PC with the USB
cable that was provided with the kit.
Connect the
larger"standard USB" connector to the USB port of the
PC.
Connect the smaller "mini-USB" connector to the Master
Controller (SV-BOX) of the 1COME VD100. Figure 1 shows a typical
USB connector on the back of a typical
PC.
Figure 1 –
Connecting 1COME VD100 to PC
| 4.1
Installing USB
Drivers |
1.
Preparation for USB installation: Installation disc of Windows® system
(It must accord with the system version
of your computer.)
2. Insert the USB interface that on the other side of
SV-BOX into computer's USB
port.
3. When you turn on computer and will
automatically see a picture like the right-hand one that
appears in the system, then insert disc or floppy and click
"Next".(Figure
2)
 Figure 2
TOP
|
4. Select
the first choice(recommanded):"Search
for the best driver for your device." and then click
"next".(Figure
3)
 Figure 3
TOP
|
5.Windows will search for new drivers in its
driver database in any of following selected locations,make
sure the "CD-ROM drive" was selected. (Figure
4)
 Figure 4
TOP
|
6.If it
shows "Please insert the disk labeled Windows 98 CD-ROM"
,insert the Windows operation system disk in CD-ROM. (Figure
5)
 Figure 5
TOP
|
7.Make sure the file source path was
correctly and the click "OK".Don't click "Cancel" and
"Skip File"(Figure 6)
 Figure
6
TOP
|
8.When the screen shows "USB Human
Interfance Device" ,the usb driver is installing
successfully.Drume system is active.(Figure
7)
 Figure
7
TOP
|
|
Notes: The installation of Windows®
98 has
the resemblance to that of Windows® ME and Windows®
XP.
Please operate it according to the
direction.
|
TOP
4.2 Inspecting methods of
"Game Controllers"
To verify that
the device was properly installed, check under the "Game Controller" section of your Windows®
Control Panel (left-click on START, then select SETTINGS, then
click on Control Panel, and double click on Game
Controller).(Figure
8)
 Figure
8
After
double-clicking on Game Controllers, if the 1COME VD100 device was
recognized and installed properly as per this section, then an
item similar to that highlighted in the circle below will be
displayed. The device serial number (shown as
VD10-6S in the example picture) will differ for each user
configuration and will therefore not be exactly the same as shown
in the example below. (Figure
9)
 Figure
9
This indicates
that the 1COME VD100 device was successfully found by your
computer. If a gaming controller is not shown, please remove the
USB cable from your system and re-insert one more time to
re-invoke the Hardware Found
Wizard. |